Influence d'un venturi sur la propagation d'un jet d'air comprimé à l'intérieur d'une manche filtrante

Résumé et principaux résultats

L'objectif de l'étude était d'évaluer expérimentalement l'impact de l'utilisation d'un venturi sur l'efficacité de décolmatage d'une manche filtrante. A cette fin, une manche filtrante (longueur 4 m) a été instrumentée (accéléromètres, sondes de pression et de vitesse de l'air) de manière à étudier la propagation d'un jet d'air comprimé à l'intérieur de la manche filtrante. Les mesures ont été effectuées avec et sans venturi en faisant varier la distance entre la buse et la manche (essais sans venturi), entre la buse et le venturi, et entre le venturi et la manche. Pour comparer les différentes configurations testées, 2 grandeurs ont été définies afin de représenter l'efficacité du décolmatage : la somme des moyennes quadratiques de l'accélération de la manche et l'amplitude de l'accélération le long de la manche rapportée à sa valeur moyenne. Sans venturi, il existe une distance buse-manche optimum (ici 200 mm) pour laquelle l'énergie transmise à la manche (secouage par accélération) est à la fois maximum est répartie de manière homogène le long de la manche. Cependant, un flux d'air induit traverse la partie haute de la manche de l'extérieur vers l'intérieur, d'où un moins bon décolmatage à cet endroit. Avec un venturi étanche, les résultats sont similaires à ceux obtenus sans venturi mais aucune distance buse-venturi optimale n'a pu être identifiée. Cette configuration est à proscrire car l'énergie apportée à la manche y est la moins homogène. Avec la configuration venturi non étanche, l'énergie est distribuée de la manière la plus homogène le long de la manche. La distance buse-venturi optimale est ici de 150 mm et il ne se dégage pas de distance venturi-manche optimale. Des 3 configurations étudiées, c'est celle que nous recommandons.
Title: Influence of a venturi on the spread of a compressed air jet within a bag filter
Abstract: The aim of the study was to experimentally investigate the influence of a venturi on the cleaning efficiency of a bag filter. So, a 4 m bag filter has been equipped along its length with accelerometers, pressure transducers and velocity probes in order to study the spread of a compressed air jet within the bag filter. Measurements have been carried out with and without the venturi for different values of the distance between the nozzle and the bag filter (without the venturi), between the nozzle and the venturi and between the venturi and the bag filter. In order to compare the different tested configurations, to parameters have been defined in order to represent the cleaning efficiency: the sum of the quadratic averages of the acceleration along the bag and the amplitude of the acceleration along the bag filter divided by the average acceleration. Minimum and maximum values of the static pressure have also been considered. When the venturi is not used, there is an optimum distance between the nozzle and the bag (200 mm in that case) for which the energy provided to the bag (shaking by acceleration) is at the same time maximum and homogeneously distributed along the bag. But in that case it has been observed that, at the top of the bag, the air passes from the dusty to the clean side of the bag resulting in a less efficient cleaning effect. When the venturi covers the bag, the results are more or less the same than with no venturi, but there is no optimum distance between the nozzle and the bag. Of the 3 tested configurations, it appears the worst (because the homogeneity of the energy distribution is poor) and it is not recommended. This is with the non covering venturi configuration that the energy distribution along the bag is the best. There is an optimum distance between the nozzle and the venturi (150 mm in that case) but no optimum distance between the venturi and the bag has been identified. Finally, of the 3 studied configurations, we recommend to use the non covering venturi.

Commissions

Dépoussiérage et épuration des gaz

Thème

Dépoussiérage et épuration des gaz

Mots-clés

Dépoussiérage, Dépoussiéreurs, Dépoussiéreurs industriels, Filtration, Filtres à manche

Auteurs

BESSAC François, BOITEUX Lionel, GINESTET Alain